On Wed, Jan 2, 2013 at 1:38 AM, Jesper Krogh <jesper@krogh.cc> wrote:
I do suspect you have too much IO going on for the hardware.
I would trim down. /proc/sys/vm/dirty_ratio and dirty_background_ratio to 2 and 1 and see if the problem goes away.
And establish graphing of the io-wait numbers if you dont have that allready.
I didn't know about this setting, thanks for the information.
I have been doing some reading on these settings and hope I am coming to an understanding. Can you help clarify whether I am understanding this properly?
So this setting is the amount of disk writes, as a percentage of the RAM both physical and virtual available, that will be held before writing to the disk? Which then would mean that the more RAM you have the more will build up before a write? So at some point there would be some trigger to fire off the write and since we have so much RAM it could take quite some time to finish the write causing the server to appear to become unresponsive?
If my understanding of this is correct and it will block all processes while until it falls under the dirty_background_ratio then the bigger the difference between the dirty_ratio and dirty_background_ratio and the more RAM and swap you have the longer it will block all processes (causing the server to appear to lock up?). That would definitely lead the the problems I am experiencing.
The odd thing is that the articles I am reading suggest increasing the dirty_ratio and decreasing the dirty_background_ratio which is the opposite of what you are suggesting.
