Tom,
It looks like I probably caused this. :-( I was not paying attention and rebooted the machine while it was doing the index building. :-( This is about an 1/2 TB warehouse instance so I am going to look at the last several thousand lines of the dump file to see if I can replay what I need to correct the situation. Not a good day.
--sean
Tom Lane wrote:
Sean Shanny <shannyconsulting@earthlink.net> writes:
My problem is that all the sequences were reset to start a 1. :-( Did
I do something wrong as this has never happened before?
Did the reload actually complete, or did it fail partway through?
Also, can I
simply figure out what the next value should be and manually update the
last_value column in each affected sequence?
No, but you could use setval().
regards, tom lane
---------------------------(end of broadcast)---------------------------
TIP 9: the planner will ignore your desire to choose an index scan if your joining column's datatypes do not match
