Hello hackers,
When I do PITR in a strange step, I get this FATAL:
2021-01-15 15:02:52.364 CST [14958] FATAL: hot standby is not possible because wal_level was not set to "replica" or higher on the primary server
2021-01-15 15:02:52.364 CST [14958] HINT: Either set wal_level to "replica" on the primary, or turn off hot_standby here.
The strange step is that I change wal_level to minimal after basebackup.
My question is that what's the mean of [set wal_level to "replica" on the primary] in
HINT describe, I can't think over a case to solve this FATAL by set wal_level, I can
solve it by turn off hot_standby only.
Do you think we can do this code change?
--- a/src/backend/access/transam/xlog.c
+++ b/src/backend/access/transam/xlog.c
@@ -6300,7 +6300,7 @@ CheckRequiredParameterValues(void)
if (ControlFile->wal_level < WAL_LEVEL_REPLICA)
ereport(ERROR,
(errmsg("hot standby is not possible because wal_level was not set to \"replica\" or higher on the primary server"),
- errhint("Either set wal_level to \"replica\" on the primary, or turn off hot_standby here.")));
+ errhint("You should turn off hot_standby here.")));
---
Regards,
Highgo Software (Canada/China/Pakistan) URL : www.highgo.ca EMAIL: mailto:movead(dot)li(at)highgo(dot)ca