Thread: manual Installation for thread safety
In order to use the --enable-thread-safety build switch I need to do a manual build... UNLESS there is a way of doing this from the RPM command line, which I have not been able to find. Where do I get 8.2.5-1? This version came with my installation of Fedora 8 so I presume it is the version I should use to ensure complete compatibility with the other software on the system.
Thanks for your help!
--
Best Regards,
Lynn P. Tilby
Ph: 480 632-8635
unixprgrmr01@gmail.com
Thanks for your help!
--
Best Regards,
Lynn P. Tilby
Ph: 480 632-8635
unixprgrmr01@gmail.com
"unixprgrmr01@gmail.com" <unixprgrmr01@gmail.com> writes: > In order to use the --enable-thread-safety build switch I need to do a > manual build... UNLESS there is a way of doing this from the RPM command > line, which I have not been able to find. Uh ... whose RPM are you using? All the PG RPMs I know of have been built with --enable-thread-safety for quite a long time. Certainly the one that comes with Fedora 8 is. regards, tom lane
On Wed, 2008-07-09 at 12:51 -0700, unixprgrmr01@gmail.com wrote: > In order to use the --enable-thread-safety build switch I need to do a > manual build... UNLESS there is a way of doing this from the RPM > command line, which I have not been able to find. Did you install redhat-rpm-config RPM? -HTH. -- Devrim GÜNDÜZ devrim~gunduz.org, devrim~PostgreSQL.org, devrim.gunduz~linux.org.tr http://www.gunduz.org