Thread: Cannot compile on Slackware 10.2

Cannot compile on Slackware 10.2

From
Dick Kniep
Date:
Hi list,

I downloaded Postgresql 8.0.4, and tried to compile on Slackware 10.2.
However, the configure runs fine, but when I run 'make' (or 'gmake') after
that, it executes the configure again (and again, and again.......), without
actually making the application.

Any ideas?

Cheers,
D.Kniep

Re: Cannot compile on Slackware 10.2

From
"Larry Rosenman"
Date:
Shot in the dark: Check your clock.


--
Larry Rosenman                     http://www.lerctr.org/~ler
Phone: +1 972-414-9812                 E-Mail: ler@lerctr.org
US Mail: 3535 Gaspar Drive, Dallas, TX 75220-3611 US

-----Original Message-----
From: pgsql-general-owner@postgresql.org
[mailto:pgsql-general-owner@postgresql.org] On Behalf Of Dick Kniep
Sent: Wednesday, October 12, 2005 10:26 AM
To: pgsql-general@postgresql.org
Subject: [GENERAL] Cannot compile on Slackware 10.2

Hi list,

I downloaded Postgresql 8.0.4, and tried to compile on Slackware 10.2.
However, the configure runs fine, but when I run 'make' (or 'gmake') after
that, it executes the configure again (and again, and again.......), without
actually making the application.

Any ideas?

Cheers,
D.Kniep

---------------------------(end of broadcast)---------------------------
TIP 2: Don't 'kill -9' the postmaster