Thread: Cursor not getting all rows
I'm running: PostgreSQL 7.4.7 on i686-pc-linux-gnu, compiled by GCC gcc (GCC) 3.2.2 20030222 (Red Hat Linux 3.2.2-5) I do this: BEGIN; SELECT count(*) FROM u, d WHERE u.id = d.id AND ... ; DECLARE cname CURSOR FOR SELECT u.field, d.field FROM u, d WHERE u.id = d.id AND ... ; At the end of the fetching if the number of fetched does not equal the number from the SELECT count(*) I print out a warning message. It happens every once in a while. Today it happened four times. 1) missed 1 out of 703773 2) missed 3 out of 703765 3) missed 10 out of 703743 4) missed 12 out of 703660 How is this possible? Because they are in the same transaction the count and the cursor should see the exact same data, right?
On Tue, 2005-05-17 at 12:19, Joseph Shraibman wrote: > I'm running: > > PostgreSQL 7.4.7 on i686-pc-linux-gnu, compiled by GCC gcc (GCC) 3.2.2 > 20030222 (Red Hat Linux 3.2.2-5) > > > I do this: > > BEGIN; > SELECT count(*) FROM u, d WHERE u.id = d.id AND ... ; > DECLARE cname CURSOR FOR SELECT u.field, d.field FROM u, d WHERE u.id = > d.id AND ... ; > > At the end of the fetching if the number of fetched does not equal the > number from the SELECT count(*) I print out a warning message. It > happens every once in a while. Today it happened four times. > > 1) missed 1 out of 703773 > 2) missed 3 out of 703765 > 3) missed 10 out of 703743 > 4) missed 12 out of 703660 > > How is this possible? Because they are in the same transaction the > count and the cursor should see the exact same data, right? Only if you set transaction isolation to serializable.
Scott Marlowe wrote: > Only if you set transaction isolation to serializable. So am I getting data that was updated up until the time of the FETCH or the DECLARE CURSOR?
Joseph Shraibman <jks@selectacast.net> writes: > I do this: > BEGIN; > SELECT count(*) FROM u, d WHERE u.id = d.id AND ... ; > DECLARE cname CURSOR FOR SELECT u.field, d.field FROM u, d WHERE u.id = > d.id AND ... ; > At the end of the fetching if the number of fetched does not equal the > number from the SELECT count(*) I print out a warning message. It > happens every once in a while. Today it happened four times. > How is this possible? Because they are in the same transaction the > count and the cursor should see the exact same data, right? Not unless you are using SERIALIZABLE mode --- otherwise the cursor will see whatever changes were committed during execution of the first SELECT. regards, tom lane
On Tue, 2005-05-17 at 12:49, Joseph Shraibman wrote: > Scott Marlowe wrote: > > > Only if you set transaction isolation to serializable. > > So am I getting data that was updated up until the time of the FETCH or > the DECLARE CURSOR? The data shouldn't change between the declare and the fetch, it's between the count(*) and the declare that it can change.