Thread: Errors installing 7.2

   I tried installing 7.2 on a "beater box", and ran into a number of
problems:

1.  if "--with-perl" is passed to ./configure, then "make" gives me:

make[4]: Leaving directory
`/usr/src/packages/postgresql-7.2/src/interfaces/libpq'
make -f Makefile all VPATH=
make[4]: Entering directory
`/usr/src/packages/postgresql-7.2/src/interfaces/perl5'
make[4]: *** No rule to make target `/Pg.pm', needed by `pm_to_blib'.
Stop.

  if I try and make the Perl libraries manually, I get pretty much the
same thing:
make -C ../../../src/interfaces/libpq all
make[1]: Entering directory
`/usr/src/packages/postgresql-7.2/src/interfaces/libpq'
make[1]: Nothing to be done for `all'.
make[1]: Leaving directory
`/usr/src/packages/postgresql-7.2/src/interfaces/libpq'
make -f Makefile all VPATH=
make[1]: Entering directory
`/usr/src/packages/postgresql-7.2/src/interfaces/perl5'
make[1]: *** No rule to make target `/Pg.pm', needed by `pm_to_blib'.
Stop.
make[1]: Leaving directory
`/usr/src/packages/postgresql-7.2/src/interfaces/perl5'
make: *** [all] Error 2


2.  If I configure it, make, and install without the Perl modules, it
runs, but trying to feed in a pg_dumpall from 7.1.2, I get the following
message repeated thousands of times:

"Invalid command - \N"

  Any advice on these would be appreciated.

steve

"Steve Wolfe" <steve@iboats.com> writes:
>    I tried installing 7.2 on a "beater box",

Er, that doesn't convey a lot ;-).  Platform, OS level, etc, please.

> 1.  if "--with-perl" is passed to ./configure, then "make" gives me:

> make[4]: Leaving directory
> `/usr/src/packages/postgresql-7.2/src/interfaces/libpq'
> make -f Makefile all VPATH=
> make[4]: Entering directory
> `/usr/src/packages/postgresql-7.2/src/interfaces/perl5'
> make[4]: *** No rule to make target `/Pg.pm', needed by `pm_to_blib'.
> Stop.

Peculiar.  What else did you pass to configure?  What Perl version
are you using?

> runs, but trying to feed in a pg_dumpall from 7.1.2, I get the following
> message repeated thousands of times:

> "Invalid command - \N"

I rather doubt that was the only message.  What did you get before
those?

            regards, tom lane