On Sat, 29 Jul 2006, Mario Splivalo wrote:
> PIRT restores are not working for me. I did it like this: I issued
> pg_start_backup, then I 'tar cvf - pg_data/ | nc destination 9876'-ed
> the cluster directory, when that was done i did pg_stop_backup, after
> that I deleted pg_xlog directory, and put new WAL files (created after
> backup begun) in directory specified in restore.conf. I started
> postgres, everything went ok. Postgres replayed wal files, and system
> was ready. Then, when new WAL files arrived, I shut down postgres, put
> WAL files in place, restarted postgres, but it complained, and didn't
> replay newly created wal files. It only does so when I 'recreate'
> original filesystem backup.
That is how PITR works. You will always have to redo the base backup before
being able to restore again, can't just start the replay from a previously
restored version. You could however, just replay from your original base
backup if you're keeping those archived WAL files.
>
>> Another option is using pgpool's replication.
>
> I considered that too, but that adds another layer between the clients
> and postgres itself, and it allows for only two servers, and I realy
> don't need failover cluster capabilities.
>
> Mike
>
>
>
--
Jeff Frost, Owner <jeff@frostconsultingllc.com>
Frost Consulting, LLC http://www.frostconsultingllc.com/
Phone: 650-780-7908 FAX: 650-649-1954
