On Tue, Feb 25, 2025 at 4:50 PM Hayato Kuroda (Fujitsu)
<kuroda.hayato@fujitsu.com> wrote:
>
> Dear Shubham,
>
> Thanks for updating the patch. Few comments.
>
> 01. CreateSubscriberOptions
> ```
> + bool cleanup_existing_publications; /* drop all publications */
> ```
>
> My previous comment [1] #1 did not intend to update attributes. My point was
> only for the third argument of setup_subscriber().
>
Fixed.
> 02. setup_subscriber()
> ```
> + pg_log_info("cleaning up existing publications on the subscriber");
> ```
>
> I don't think this output is needed. check_and_drop_existing_publications() has the similar output.
>
Fixed.
> 03. drop_publication_by_name()
> ```
> +
> + appendPQExpBuffer(query, "DROP PUBLICATION %s", pubname_esc);
> + pg_log_info("dropping publication %s in database \"%s\"", pubname, dbname);
> + pg_log_debug("command is: %s", query->data);
>
> ```
>
> Currently, appendPQExpBuffer() is done after the pg_log_info(). Please reserve current ordering if
> there are no reasons. Also, variable "str" is currently used instead of query, please follow.
>
Fixed.
> 04. drop_publication_by_name()
> ```
> if (!dry_run)
> {
> - res = PQexec(conn, str->data);
> + res = PQexec(conn, query->data);
> if (PQresultStatus(res) != PGRES_COMMAND_OK)
> + dbinfo->made_publication = false;
> + else
> {
> - pg_log_error("could not drop publication \"%s\" in database \"%s\": %s",
> - dbinfo->pubname, dbinfo->dbname, PQresultErrorMessage(res));
> - dbinfo->made_publication = false; /* don't try again. */
> -
> - /*
> - * Don't disconnect and exit here. This routine is used by primary
> - * (cleanup publication / replication slot due to an error) and
> - * subscriber (remove the replicated publications). In both cases,
> - * it can continue and provide instructions for the user to remove
> - * it later if cleanup fails.
> - */
> + pg_log_error("could not drop publication %s in database \"%s\": %s",
> + pubname, dbname, PQresultErrorMessage(res));
> }
> ```
>
> pg_log_error() is exected when the command succeed: This is not correct.
>
Fixed.
> 05. 040_pg_createsubscriber.pl
> ```
> +# Set up node A as primary
> +my $node_a = PostgreSQL::Test::Cluster->new('node_a');
> +my $aconnstr = $node_a->connstr;
> +$node_a->init(allows_streaming => 'logical');
> +$node_a->append_conf('postgresql.conf', 'autovacuum = off');
> +$node_a->start;
> ```
>
> I don't think new primary is not needed. Can't you reuse node_p?
>
Fixed.
The attached patch contains the suggested changes.
Thanks and regards,
Shubham Khanna.
