Oscar Tuscon <obtuse@bmwe30.net> writes:
> I'm looking at ways to get batches of sequence values s faster. I don't want to set cache or increment to a large
numberfor a variety of reasons. I need to grab id's in batches of varying numbers at various times, from 1 to several
thousandat once.
> Doing it 1 at a time works, but more time goes into it than I'd like. I tried setting cache_value high but the
databaseroundtrips were eating more time that I wanted to see; I only saw a 25% improvement in average time.
>
> SO... is the following approach safe? That is, will this be atomic, or is there a possibility that another connection
couldsqueeze in a select nextval() between the select nextval() and the setval below?
> If it's safe I'd do this and take the sequences as the new currval - #I asked for (1500 or whatever).
>
> mydb=# select setval('my_id_seq', (select nextval('my_id_seq')+1500));
I'm not sure but I don't think that's safe since nextval doesn't lock the
sequence until the setval occurs. Though it might be unlikely to actually
occur in real life.
You could create a table with as many entries as you will ever need and then
select nextval() from that table and read all the records you get. That will
avoid the many round trips but it will still be slow since you will still have
to move all those individual values to your client.
Perhaps you should give up on the idea of using sequences at all.
If you have a table with one record (or one record per similar application).
You could "SELECT n FROM counters FOR UPDATE" the value in the record, then
"UPDATE counters SET n = n+?". It would serialize your accesses which would be
bad if you had lots of clients doing small increments, but if you have few
clients doing large increments it shouldn't be a problem.
Do make sure to vacuum this table frequently though.
--
greg
