On 3/17/25 14:28, Andrei Lepikhov wrote:
> Hi,
>
> As I see, initial pruning doesn't work in the case when a
> ScalarArrayOpExpr contains a parameter as the RHS of the expression,
> like following:
>
> partkey = ANY($1)
>
> As colleagues say, it is quite typical to use stored procedures, pass an
> array of IDs as a parameter, and use it in a SELECT clause.
>
> So, here I propose a patch that extends pruning machinery. It is nothing
> innovative or complicated, but I'm not sure it is fully operational so
> far: it may need some discussion, review and polishing.
>
> I intended to add it to the next commitfest if this feature makes sense.
For the record, here I want to resolve a bit more general issue, than
just pruning on a "key op ANY($1)" expression. For example, a hashed
InitPlan also may be used for this purpose:
CREATE TABLE part (a int)
PARTITION BY RANGE (a);
CREATE TABLE part1 PARTITION OF part FOR VALUES FROM (0) to (101);
CREATE TABLE part2 PARTITION OF part FOR VALUES FROM (101) to (200);
INSERT INTO part (a) SELECT value%200 FROM generate_series(1,1000) AS value;
CREATE TABLE other (x int, y int);
INSERT INTO other (x,y) VALUES (1,1);
EXPLAIN (VERBOSE, ANALYZE, COSTS OFF, TIMING OFF, BUFFERS OFF)
SELECT * FROM part
WHERE a = ANY((SELECT array_agg(x) AS x
FROM other
WHERE y between 0 and 100)::integer[]);
I think subqueries is quite a common pattern and pruning in this case
makes sense.
--
regards, Andrei Lepikhov
