On 06/05/2018 05:43 AM, Tom Loder wrote:
> I am using Postgres 10.4, and using replication, I have managed to set up four servers, with one running as a master
andthe other three running with streaming replication from the master.
>
> I have used the command:
> psql -c "ALTER SYSTEM SET synchronous_standby_names TO 'FIRST 1(S2,S3,S4)';" so that at least one of the three slave
clustersare SYNCED to the master.
>
> If I run the following command I get the following back:
>
> SELECT pid, usename, application_name as name,state, client_addr, sent_lsn, write_lsn, flush_lsn, replay_lsn,
sync_priority,sync_state FROM pg_stat_replication;
>
> pid | usename | name | state | sent_lsn | write_lsn | flush_lsn | replay_lsn | sync_priority | sync_state
>
-------+---------+-------+-----------+-------------+-----------+-----------+-----------+------------+---------------+------------
> 26215 | replica | S3 | streaming | 0/6000000 | 0/6000000 | 0/6000000 | 0/6000000 | 2 | potential
> 26200 | replica | S4 | streaming | 0/6000000 | 0/6000000 | 0/6000000 | 0/6000000 | 3 | potential
> 26186 | replica | S2 | streaming | 0/6000000 | 0/6000000 | 0/6000000 | 0/6000000 | 1 | sync
>
> When I take out my master server (S1) I setup S2 as the master using a bash script and I update the recovery.conf
fileson the other two servers to change the replication to run from S2.
I am not sure what is going on here as I am not that familiar with
synchronous replication. I do think it would aid those that can help if
you provided the contents of :
1) The Bash script
2) The recovery.conf file.
Also are there relevant log entries for S2, S3 and S4?
> I have changed the setting for synchronouse_standby_names using:
>
> psql -c "ALTER SYSTEM SET synchronous_standby_names TO 'FIRST 1(S1,S3,S4)';" hoping that one of the remaining two or
possiblythe old master will SYNC to the new master (S2).
>
> However when I check on S2 I get the following output from pg_stat_replication:
>
> pid | usename | name | state | sent_lsn | write_lsn | flush_lsn | replay_lsn | sync_priority | sync_state
>
------+---------+-------+---------+-------------+-----------+-----------+-----------+------------+---------------+------------
> 6418 | replica | S4 | startup | 0/D000098 | 0/D000098 | 0/D000098 | 0/D000098 | 3 | potential
> 6417 | replica | S3 | startup | 0/D000098 | 0/D000098 | 0/D000098 | 0/D000098 | 2 | potential
>
> If I also get the original master (S1) running and set it up as a Slave this also will not "SYNC". How can I get the
standbyservers to SYNC to the new Master (S2) without doing a new BaseBackup from S2 to the other servers?
>
> Thanks
>
> Tom
>
>
>
>
>
>
>
>
--
Adrian Klaver
adrian.klaver@aklaver.com
