Re: Freebsd & autoconf-2.63 - Mailing list pgsql-hackers

From abindra@u.washington.edu
Subject Re: Freebsd & autoconf-2.63
Date
Msg-id Pine.LNX.4.43.0911060830030.13707@hymn11.u.washington.edu
Whole thread Raw
In response to Re: Freebsd & autoconf-2.63  (Tom Lane <tgl@sss.pgh.pa.us>)
List pgsql-hackers
Thanks Tom. Heikki's suggestion resolved the issue.

On Fri, 6 Nov 2009, Tom Lane wrote:

> abindra@u.washington.edu writes:
>> I downloaded the latest postgresql code via cvs on a FreeBSD 7.2 system. When I try to run autoconf on the source it
tellsme that I need autoconf-2.63. However the freeBSD ports only has autoconf-6.62.
 
>
>> Does anyone have any suggestion on how to resolve this? I posted a question on the freebsd ports forum but have not
hadany solutions.
 
>
> Well, you could grab our nightly tarball instead of pulling from CVS.
> Or you could remove the version-check line from configure.in.  The
> latter is actually very likely to work, we just don't promise anything
> (if it breaks, debugging is your problem not ours).
>
>             regards, tom lane
>




pgsql-hackers by date:

Previous
From: Tom Lane
Date:
Subject: Re: "ERROR: could not read block 6 ...: read only 0 of 8192 bytes" after autovacuum cancelled
Next
From: Alvaro Herrera
Date:
Subject: Re: "ERROR: could not read block 6 ...: read only 0 of 8192 bytes" after autovacuum cancelled