Is the library located in a directory listed in a directory listed in
ld.so.conf ? have you run ldconfig?
Hope this helps.
-Ed Dembowski
-----Original Message-----
From: Tom Good [SMTP:tomg@nrnet.org]
Sent: Wednesday, April 01, 1998 11:50 AM
To: pgsql-interfaces@postgreSQL.org
Subject: [INTERFACES] ecpg libraries
Hello - I am running Postgresql6.3 on three boxes, each running
slackware3.1 (kernel 2.0.27). Each install went similarly -
over
the course of a week I installed 3 full src trees, created dbs,
made some tables, populated them and then ran make against the
ecpg dir.
I can compile and link on all 3 boxes but 2 of 3 complain when I
try to run the binaries: `can't load libecpg.so'.
In each case, permissions and ownership look good.
Anything obvious I am not seeing???
Thanks,
Tom
----------- Sisters of Charity Medical Center ----------
Department of Psychiatry
----
Thomas Good, System Administrator
<tomg@q8.nrnet.org>
North Richmond CMHC/Residential Services Phone:
718-354-5528
75 Vanderbilt Ave, Quarters 8 Fax:
718-354-5056
Staten Island, NY 10305
