> >> > * Not correspond yet
> >> >
> >> > ?* full_page_write = off
> >> > ? ?-> If the primary is "full_page_write = off", archive recovery may not act
> >> > ? ? ? normally. Therefore the standby may need to check whether "full_page_write
> >> > ? ? ? = off" to WAL.
> >>
> >> Isn't having a standby make the full_page_write = on in all case
> >> (bypass configuration) ?
> >
> > what's the meaning?
Thanks.
This has the following two problems.* pg_start_backup() must set 'on' to full_page_writes of the master that is
actualwriting of the WAL, but not the standby.* The standby doesn't need to connect to the master that's actual writing
WAL. (Ex. Standby2 in Cascade Replication: Master - Standby1 - Standby2)
I'm worried how I should clear these problems.
Regards.
--------------------------------------------
Jun Ishizuka
NTT Software Corporation
TEL：045-317-7018
E-Mail: ishizuka.jun@po.ntts.co.jp
--------------------------------------------
