> Le Mercredi 20 Février 2002 01:50, Tatsuo Ishii a écrit :
> > The error messages shows your data contains an invalid UTF-8 character
> > sequence. The first byte (e8) expects the UTF-8 sequence consists of 3
> > bytes, each of 8th bit on. However the third byte is 0x27, apparently
> > it does not satisfy the requirement. Check your data.
Dear all,
Can anyone help me understand where the problem stems from.
1) Is this a data perversion problem (=wrong UTF-8 sequences entered)? Then,
how can I fix it? Why did 7.1.3 allow the input of such data?
2) The data was created with pg_dump. It loads without problem in 7.1.3. But
not in 7.2. Why?
3) Ultimately, please tell me if I can use ADODB odbc calls to migrate UTF-8
data using VB. Are there special settings required? Should I wait for a fix
in 7.2 or should I go for VB right now?
I am stuck and cannot work anymore (my new code is on 7.2, the old data is on
7.1.3). Thank you for your help,
Cheers,
Jean-Michel POURE
