The bre-built version is not really an option in my case, since I need to
comment-out some of the warning messages to make it compatible with
PostGIS/MapServer applications that I'm using.
I'd prefer if someone could point out the source of the problem...I haven't
received any errors throughout the configure/make/install sequence, only with
the initdb command. I don't understand the contents of the initdb script well
enough to figure it out on my own...
Thanks,
Mike
Quoting Jason Tishler <jason@tishler.net>:
> Mike,
>
> On Tue, Dec 09, 2003 at 01:12:16PM -0500, Mike Leahy wrote:
> > I just compiled and installed PostgreSQL 7.4 on a cygwin/WinXP
> > platform. When I try to run the initdb command, I get the results
> > below. Has anyone had a similar problem, and/or does anyone know what
> > I should do to get around this?
>
> Use the pre-built version, if possible.
>
> Jason
>
> --
> PGP/GPG Key: http://www.tishler.net/jason/pubkey.asc or key servers
> Fingerprint: 7A73 1405 7F2B E669 C19D 8784 1AFD E4CC ECF4 8EF6
>
> ---------------------------(end of broadcast)---------------------------
> TIP 7: don't forget to increase your free space map settings
>
----------------------------------------
This mail sent through www.mywaterloo.ca
