I understand that it's possible to promote a "hot standby" pg server
simply by creating the failover file. In a scenario where there are
multiple standby servers, is it possible to point the other standby
servers to the new master without creating a new base backup?
When I tried to do this, I ran into the "timeline 2 of the primary
does not match recovery target timeline 1". I'm just trying to figure
out if that's because the procedure I followed to promote the standby
was wrong or because it's just not possible.
Thanks,
Andy
--
Andy Chambers
Software Engineer
(e) achambers@mcna.net
(t) 954-682-0573
CONFIDENTIALITY NOTICE: This electronic mail may contain information
that is privileged, confidential, and/or otherwise protected from
disclosure to anyone other than its intended recipient(s). Any
dissemination or use of this electronic mail or its contents by
persons other than the intended recipient(s) is strictly prohibited.
If you have received this communication in error, please notify the
sender immediately by reply e-mail so that we may correct our internal
records. Please then delete the original message. Thank you.
