Andy Fan <zhihui.fan1213@gmail.com> writes:
> Thank you for this code! I still have some confusion about when a SubPlan
> should be executed when a join is involved. I care about this because this
> has an impact on when we can get the num_exec for a subplan.
> The subplan in a target list, it is executed after the join in my case.
> The subplan
> can be execute after the scan of T1(see below example) and it can also be
> executed
> after the join. Which one is better depends on which methods make the
> num_exec
> smaller. Is it something we already considered?
Uh, I'm not following your concern. SubPlans appearing in the join
targetlist *must* be executed "after the join", ie only for valid
join rows. Otherwise we could have cases where, say, they throw
errors that should not occur. On the other hand, SubPlans appearing
in the join's qual conditions have to be executed "before the join",
although exactly what that means is fuzzy because we don't make any
promises about the relative ordering of different qual conditions.
> When the subplan is in a Qual, it is supposed to be executed as soon as
> possible,
> The current implementation matches the below cases. So can we say we
> knows the num_execs of SubPlan just after we plan the dependent rels?
I wouldn't say so. If the SubPlan's qual actually only depends on one
of the input rels, distribute_qual_to_rels would have pushed it down
further than the join. Among the quals that do have to be evaluated
at the join, a qual involving a SubPlan is best executed last on cost
grounds, or so I'd guess anyway. So the number of executions is probably
less than the product of the input rel sizes. That's what motivates
the choice of NUM_EXEC_QUAL in my patch.
regards, tom lane
