Re: cygwin installation problem (windows platform) - Mailing list pgsql-admin

From mike g
Subject Re: cygwin installation problem (windows platform)
Date
Msg-id 1087791477.2187.2.camel@localhost.localdomain
Whole thread Raw
In response to cygwin installation problem (windows platform)  ("Harry" <xghuang@cs.aau.dk>)
List pgsql-admin
What version of postgres did you install?  If it is 7.4.2 or later then
you must install the cygserver package and start that.  ipc-daemon2 is
not being used anymore.

Mike
On Wed, 2004-06-16 at 08:00, Harry wrote:
> Hi all,
>    I install cygwin in my windows2000 so as to install postgresql. When I
> use the postgresql installed together with cygwin, I came into this problem:
>    First, I run
>       ipc-daemon2 &
>    Second, when I try to initialize the database by running the following
> command,
>       initdb -D /usr/local/pgsql/data
>    I got some problem, here are the output
> .....(the above step is OK)
> creating configuration files... ok
> creating template1 database in /usr/local/pgsql/data/base/1... Signal 12
> initdb: failed
>    I download the source code of postgresql (7.4.2) and compile it under the
> cygwin and run the above again. The same problem happens. Here are the
> output after running initdb.
> ........( The above is OK)
>    creating configuration files... ok
> creating template1 database in /usr/local/pgsql/data/base/1... FATAL:
> semctl(35
> , 16, SETVAL, 536) failed: Invalid argument
> initdb: failed
>
>   What shall I do with this problem?
>
> Thanks
> Harry
>
>
>
> ---------------------------(end of broadcast)---------------------------
> TIP 1: subscribe and unsubscribe commands go to majordomo@postgresql.org

pgsql-admin by date:

Previous
From: Grega Bremec
Date:
Subject: Re: Is this a "Stupid Question" ?
Next
From: Grega Bremec
Date:
Subject: Re: mssql and postgres